Skip to main content

Settings

The Settings page enables you to view and edit Control Room configurations such as regional settings, alerts, email, domain settings.

Note: Control Room installation wizard will allow you to configure most of these settings during deployment. The Settings page will enable you to change these configurations post-deployment of Control Room.

Note: The tick mark on the Tab indicates successful configuration. The exclamatory symbol on the Tab indicates the incomplete configuration of settings. Any incomplete configuration of settings leads to failure of the corresponding feature.

General Settings#

You can view and configure the following settings under this Tab:

SettingDescription
Control Room VersionDisplays the version information of the deployed Control Room in read-only mode.
Domain NameThe Active Directory domain name to be used to pull users into Control Room
LifetimeThe time in minutes before the authentication token expires. By default, this is set to 30 minutes.

You need to save the configuration by clicking on the Save button for the settings to take into effect.

SMTP Settings#

You can view and configure SMTP-based email server settings under this Tab. Control Room would use the configured settings to send alerts and notifications to users.

SettingDescription
ServerThe SMTP email server name
Email AddressEmail account required to login into email server
Passwordnecessary password to login into email server
PortEmail server listening port
Maximum Retry Count on FailureNumber of times to retry in case of failures
Display NameDisplay name to be used inside From field while sending email
Use SSLSend an email over Secured Socket Layer (SSL)

Note: You can test your SMTP configuration by clicking on the Test Mail button. It will send a test email to your email account from the account configured under this Tab.

You need to save the configuration by clicking on the Save button for the settings to take into effect.

Regional Settings#

You can view and configure the regional settings under this Tab. These are global settings applied to all automation users.

SettingDescription
Date FormatThe display format for date values. Default format: DD/MM/YYYY
Time ZoneThe time zone of the Control Room. Default time zone: UTC
LocaleThe language of the Control Room user interface. Default language: English
Time FormatThe display format for Time values. The available options are either 24-hour or 12-hour representation. Default format: 12-hour

You need to save the configuration by clicking on the Save button for the settings to take into effect.